Analogue Haven
The Analogue Haven Menu who are the guys behind analogue haven? analogue haven on instagram analogue haven on vimeo what stuff does analogue haven sell? buy some used gear modular grid view your cart send an email to analogue haven 
back to main 4ms page 
 

4ms
row power 30

price : $119.00



Row Power 30

row power 40

price : $155.00



Row Power 40

power brick 90w

price : $25.00





Power Brick 90W

barrel to barrel cable

price : $15.00





Barrel To Barrel Cable

bus stick (shrouded)

price : $40.00





Bus Stick (Shrouded)

bus stick with bare headers (unshrouded)

price : $35.00





Bus Stick with Bare Headers (Unshrouded)

flying bus with male pins
2 keyed cable sets

price : $25.00



Flying Bus with Male Pins (2 Keyed Cable Sets)

row power is a clean, regulated, and protected power solution for eurorack systems. row power 30 provides 30w of power, suited for any typical eurorack row (+12@1.5a/-12@.75a/5@.5a) row power 40 provides 40w of power, suited for up to two typical eurorack rows (+12@1.5a/-12@1.3a/5@1.5a).

simply plug a laptop style power supply into either of the barrel plugs on the 4hp panel. connect your modules via flying-bus cables, or connect the row power to a distro board.

daisy-chain multiple row powers to use a single power brick for multiple rows. each row will be independently regulated and protected for ultra-low cross-talk between rows. rows can also be hot-swapped (plugged/unplugged without powering the whole system down).

features:
two power jacks for daisy-chaining multiple row powers: a common laptop-style power brick could power 3-5 rows (typical)
on/off switch cuts power without interrupting the daisy-chain
row power 30 (white panel) provides more than enough power for a 84hp or 104hp row of modules.
row power 40 (black panel) is suited for up to 2 typical eurorack rows
ultra-clean: each rail is separately regulated with high-grade components
runs cool: row power is efficient so it won't heat up your system. electronics like to chill!
skiff-friendly: only 28mm (1.1") with power connectors installed.
cv/gate headers for expansion
pcb pads for blade tabs for power entry, to be used in custom installations (e.g. if the 4hp panel is not used)

specifications:
row power 30: +12v @ 1.5a, -12v @ 0.75a, +5v @ 0.5a
row power 40: +12v @ 1.5a, -12v @ 1.25a, +5v @ 1.5a
powered by laptop-style dc power supply: 2.1mm barrel, positive center, 15v-20v.
a 90w power brick typically powers about 416hp (4 rows of 104hp).
4hp
24mm deep (0.96"), up to 28mm (1.1") with power cable

download the user manual here.

Analogue Haven