earthquaker devices avalanche run: stereo reverb & delay w/tap tempo (limited edition; aurora borealis) price : $299.00

the avalanche run is a dreamy stereosonic exploratory multi-tool that includes up to 2 seconds of delay time, reverse delay, tap tempo with subdivision control, switchable true bypass or buffered bypass with 5 different tail lengths (including a sound-on-sound style lo-fi looping mode) and an assignable expression control that maps the expression jack to a control of your choice, including the toggle! the delay section allows tweaking from tape emulation to bucket brigade styles with a twist of the wide-range tone control. the cavernous, plate-style reverb has just a touch of modulation similar to the one found in our precious dispatch master only more lush with an adjustable decay. otherworldly reverse delay and dynamic swelling reverb settings are accessible through a 3-way toggle switch. and that's just the beginning...

specifications:
dimensions: 4.65 x 4.15 x 2.25 in. (118 x 105 x 57 mm) with knobs
current draw: 410 ma
input impedance: 1 mΩ
output impedance: 100 Ω
s/n ratio: 115db typical

24-bit 96khz a/d & d/a converters
all analog dry signal path
all digital wet signal path with 20hz - 20khz frequency response

expression jack
the expression jack is located on the west side of the pedal. it is a trs jack with the tip acting as the wiper. we recommend using a moog expression pedal with the output adjustment knob all the way up. we cannot guarantee any other expression pedal to work \ with the avalanche run.

flexi-switch® technology
this device features flexi-switch® technology! this relay-based, true bypass switching style allows you to simultaneously use momentary and latching style switching.
for standard latching operation, tap the footswitch once to activate the effect and then tap again to bypass.
for momentary operation, hold the footswitch down for as long as you'd like to use the effect. once you release the switch the effect will be bypassed.
since the switching is relay based, it requires power to pass signal.

power
this device takes a standard 9 volt dc power supply with a 2.1mm negative center barrel. we always recommend pedal-specific, transformer-isolated wall-wart power supplies or multiple isolated-output supplies. pedals will make extra noise if there is ripple or unclean power. switching-type power supplies, daisy chains and non-pedal specific power supplies do not filter dirty power as well and let through unwanted noise. do not run at higher voltages!

download the operation manual here.